Safety – Page 6

• 1092For what reason are weights installed on the tractor’s front?
• 1093For what reason are weights installed on the tractor’s front?
• 1094What is the function of the tractor’s differential lock?
• 1095Is it possible to brake only one wheel in a tractor?
• 1096When is it required to brake only one wheel in a tractor (brake separation)?
• 1097Is it permitted to drive a tractor with brakes that are permanently separated?
• 1098What is the function of the tractor’s PTO (“Power Take Off”) power transfer?
• 1099What RPM (Rounds per Minute) level should be determined to operate the tractor’s PTO (“Power Take Off”) power transfer?
• 1100What is the most important safety rule while operating a PTO power transfer?
• 1101What is the meaning of the PTO power transfer “standard operating speed’?
• 1102When should the tractor’s differential be locked?
• 1103What is forbidden to do after the differential is locked?
• 1104Which tractor-derived pressure is used to operate attachments and additional equipment?
• 1105What should be ensured before disengaging the hydraulic oil pipe connectors from the tractor’s attachment or from the tractor’s additional equipment?
• 1106How would you release the hydraulic oil pressure before disconnecting the supply piping from the tractor’s attachment or additional equipment?
• 1107When is it obligatory to install a spark protector on a tractor?
• 1108Where is the permitted to untie tools or a trailer from the tractor?
• 1110What is the function of the tractor’s middle lift arm (“the third point”)?
• 1111Which action should be taken after the tool is harnessed to the hydraulic lift arms?
• 1112How would a tractor and its trailer maintain low speed during a long and steep descent?
• 1183It is prohibited to drive too close to the vehicle in front of you:
• 1274What is a bus driver required to check before moving the bus?
• 1277What risks are expected when the bus driver makes a sudden brake?
• 1291The ability to control the vehicle in order to prevent accidents:
• 1292What should a driver do when he approaches a road section on which oil was spilled?
• 1293What should a driver do when the road has bumps and cracks?
• 1296Under which conditions is it advised to turn on the lights during the day?
• 1298Non adjusted headlights:
• 1331On which part of the semi trailer is a 6.10 meter long freight container loaded?
• 1332When you apply the brake pedal during an emergency braking:
• 1360Which vehicles must be equipped with a fire extinguisher?
• 1389Can unprescribed medications have a negative effect on driving?
• 1397Is it obligatory to use an appropriate lower gear on every steep descent?
• 1417What is a driver required to do after crossing a flooded road section?
• 1459You are driving a heavy truck down a steep and long descent. When should you shift to an appropriate low gear?
• 1460What is the risk in shifting gears while driving a heavy vehicle down a steep descent?
• 1461After connecting a trailer to a towing vehicle or to a truck, is it required to check brake response?
• 1462When you are driving a truck down a steep descent:
• 1464What factors affect the stability of a freight-carrying commercial vehicle while driving in a curve?
• 1466The higher is the vehicle’s center of gravity:
• 1469How would you connect the truck cabin to the semi-trailer?
• 1470What risk is a rigid vehicle with trailer or a semi-trailer truck expected to face while driving on a slippery roadway?
• 1476What might be the effect of sand scattered on the road?
• 1480When is a vehicle affected by centrifugal force?
• 1481How is it possible to reduce the centrifugal force applied to the vehicle whilst driving?
• 1483Why is it required to drive in low gear on a steep descent?
• 1489The reaction distance depends on:
• 1490The reaction distance is the distance covered by the vehicle:
• 1491What is the correct sentence?
• 1492You are driving on a two-way road and in front of you drives a vehicle that signals with its left indicator: